Utility Relay Company AC-PRO-II, Инструкция по эксплуатации

Страница: 19 / 56

AC-PRO-II
®
Instruction Manual www.utilityrelay.com
Page 17
The trip unit internal battery state can be tested and
viewed using the MORE menu. Press “MORE”, then press
“Util”, then “Next” as shown below.
At the battery state screen, the battery voltage is not
displayed until a battery test (during the current trip unit
power cycle) is performed by pressing the test button.
PWR SET HIST MORE
N:
GF:
xxxxA
xxxxA
xxxxA
xxxxA
xxxxA
xxxVan
xxxVbn
xxxVcn
A:
B:
C:
URC
Time Exit Next
Utility Relay Co.
TRIP UNIT Information
S/N xxxxxxxxxx
Firm. Rev. x.x.xx.xxx
Exit
Time And Date
xx:xx:xx PM
xx/xx/xxxx
AC-PRO-II
Exit
Exit Back
Utility Relay Co.
www.utilityrelay.com
Phone (888)289-2864
Change
Time And Date
xx:xx:xx PM
xx/xx/xxxx
Up Down Exit Next
Utility Relay Co.
DISPLAY Information
S/N xxxxxxxxxx
AC-PRO-II LOCAL
Back
Exit
Battery Test x.x V
Battery State
Back Test
The Voltage values and
"PWR" button only appear if
the optional Voltage Divider
Module (VDM) is connected.
The Battery Test
voltage is blank until
"Test" is pushed, after
which the voltage is
displayed.
If Battery voltage is
less than 2.2V, the
"**REPLACE
BATTERY**"
message appears.
**REPLACE BATTERY**
Firm. Rev. x.x.xx.xxx
Press MORE to access MORE Menu
o
o
o
"Up" and "Down" are used to
change values. The "Next"
button is used to proceed to the
next setting. The "Back" button
and "AM" & "PM" buttons will
also appear in the Time & Date
setting sequence.
Separate serial
numbers are reported
for Trip Unit and Local
Display since they can
be separated.
Util
Manually Clear All
Alarms and Reset
Next Reset Exit Back
Clear Back
MAIN
"READINGS"
SCREEN
Alarm Relay?
Confirm Clear/Reset?
This may take up to
10 seconds. Screen
will shut off when
Alarm relay resets.
Figure 6.5: MORE Menu
6.4.2 Battery Test and Status