![Utilimaster REACH Скачать руководство пользователя страница 95](http://html.mh-extra.com/html/utilimaster/reach/reach_service-manual_1065305095.webp)
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
of Utilimaster.
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
95
For Assistance Call: 800-237-7806
Parts On-line:
https://parts.utilimaster.com
Reach—Body Service Manual
Fax: 574-862-7637
Quarter Glass Removal
1. Remove mirror.
2. Remove A-pillar trim.
3. Remove front quarter fender.
4. Remove trim.
5. Remove the urethane sealant with a pneumatic knife or utility knife. The use of a wire style
cutter may be required to remove the urethane sealant that is closer to the body of the vehicle.
6. Remove quarter glass and discard.
Substructure Prep
1.
If the old adhesive is bonded firmly to the frame and not
peeling from the surface, trim the bead down to 1/16" to
1/8". If old adhesive is loose, remove all adhesive down
to metal surface.
2. Use Medium Red Scotch Brite to roughen surface of any
bare metal area of mounting frame.
3. Clean entire aluminum bond area with isopropyl alcohol.
Allow two minutes drying time.
4. Wiping in one direction, use a clean cotton rag or lint-free paper towel and apply activator to
the exposed metal of mounting frame. Turn rag several times to avoid transferring dirt and oil.
Drying time is ten minutes.
5. Brush a light coat of primer (P/N 12605827) on exposed metal of mounting frame. Drying time
is ten minutes.
Trim sealant bead
CAUTION: Do NOT use lacquer thinner or mineral spirits.