![Utilimaster REACH Скачать руководство пользователя страница 138](http://html.mh-extra.com/html/utilimaster/reach/reach_service-manual_1065305138.webp)
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
of Utilimaster.
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
For Assistance Call: 800-237-7806
Visit us at:
www.utilimaster.com
138
Reach—Body Service Manual
E-mail:
Mode (Servo) Motor
There are four mode (servo) motors on the heating and air-conditioning unit. The motors operate the
recirculation, floor, dash, and defrost doors. All motors are serviced the same.
NOTE: To access the floor, dash, or defrost servo motors, remove the dash valance panel.
NOTE: To access the recirculation servo motor, remove the washer bottle panel.
Removal
NOTE: Keep all hardware for reinstallation.
1. Remove the wire harness by pressing the tab on the top of the servo motor.
2. Remove three 8/32" locknuts.
3. Pull motor off mounting studs and set aside.
Servo motor wire harness
Locknuts on servo motor