The Utile Engineering Co. Ltd.
27/11/03
Irthlingborough, Northamptonshire. England
Tel: +44 (0) 1933 650216
Fax: +44 (0) 1933 652738
14
IC162
6.13
Press the outer race of roller bearing (15) into position in the coverplate (2).
6.14
Fit new o-ring (18) into the coverplate groove. If coverplate gasket (54) has been replaced, it is essential
that they are the same thickness as the originals, otherwise internal clearances will be affected and could
cause serious damage. Lightly smear the gasket with oil before positioning onto cylinder (1).
6.15
Place drive coverplate assembly onto cylinder (1) with coverplate gasket via location dowels and fix with 6
screws (25) and shakeproof washers.
6.16
Secure ball bearing (16) in place with any shims, the bearing retaining washer (7) and circlip (19).
6.17
Press the shaft seals (17) into the end cap (3) as fig 9.
6.18
The end cap (3) can now be fitted onto the coverplate assembly complete with the gasket (55) and any
appropriate shims.
Check that the shaft rotates freely by hand.
6.19
Reposition support plate (8) complete with oil pump assembly and tighten clamp screw (27). Refit drive
pulley (58) and timing belt (61).
Reassemble 4-way valve
6.20
Remove tape or refit non-return valve (51) complete with washers (53) and screws (52).
6.21
Place 4-way valve assembly in correct orientation on top of cylinder flanges with valve body gasket (49) in
position.
Refit oil pipes. Prime oil pipes before use. Reassemble ballast valve assembly.
7. Spare
Parts
A stock of the main wearing parts at the installation site is important to the constant availability and smooth running
of the machine. We recommend the following parts and quantities to be kept in stock at the installation site.
Part Number
Description
LW700
Quantity
Blade
S 8808/1
6
Ball Bearing
H 1028
1
Roller Bearing
H 1029
1
Shaft Seal
F 1089/V
4
Gasket – Coverplate
K 1033
2
Gasket – End Cap
S 8544/2
2
O-Ring – Coverplate
F 1071
2
Gasket – Valve Body
S 9288
1
Gasket – Valve Cover
S 9289
1
O-Ring – Ballast Manifold
F 1262
1
Timing Belt
P 1026
1
Drive Belt / Drive Coupling
1
Always quote the machine serial number when ordering spare parts.
After Sales Service
Contact the address or telephone number shown at the bottom of each page or our local distributor, for any after
sales service, maintenance or service problems.
Contract maintenance, service exchange machines or a site visit by a Utile Engineering Service Engineer can also
be arranged in the same manner.
Utile Engineering can also provide Training Programs for all your requirements, from maintenance repair to
operator and supervisor training. They are structured to give specialist knowledge of our products and procedures
including use of authorised spares. The enacting of the Health and Safety at Work Act focused attention on the
responsibility of all parties, manufacturers, users and repairers on the repair of equipment. We strongly recommend
that repairs should be carried out to the original specification using authorised replacement parts where necessary.
Spare Parts
After Sales Service
