April 2010
Page | 6
2.3
ACCESING CONNECTORS AND SWITCHES
The ToughSmartMarquee has an Access/Cover plate on its backside. This is a gasketed cover plate
with two sealed grommets for power and communication cables. The gasket and the grommet seal
must be intact to retain NEMA 12 rating. Once you remove the cover plate by removing the four
access screws on the plate, you have access to wiring terminals required for marquee
communication.
See picture below:
Fig 2.1.1 Marquee Board Fig 2.1.2 Connectors for User’s
Wiring Purpose
Dip Switches:
Ethernet Port:
CAUTION!
Please DO NOT TOUCH any of the DIP switches. They are
for factory use only! Changing DIP switches may make the product
inoperable.
CAUTION!
If there is a second Ethernet Port available on the Marquee
board,please use only the Ethernet Port1 shown in fig 2.1.2, for
Marquee programming and communication purposes.
DO NOT use Ethernet Port2 (marked in Fig 2.1.1 )
