background image

 Feature

1

2

● Standard : IEC61643-21:2000 standard
● Protection: Ethernet signal(bandwidth ≤ 100Mbps);
● Feature: Multi-level over voltage protection, large capacity discharge current, low limiting  
     voltage, quick reacting time, low inserting loss;
● Grounding mode: Extending line to the ground;
● Design :Clear mark, easily recognized, aluminum shell, support desktop or on-wall installation. 

;

The surge protector is an 100M ethernet signal surge protector based on IEC61643-21:2000 
standard. The equipment nominal voltage is 5V, maximum continuous running voltage is 6V, 
limit  voltage  is  less  than  20V.  It  features  multi-level  protection,  large  maximum  discharge 
current,  low  limiting  voltage,  quick  reacting  time,  low  inserting  loss  etc..It  is  adapted  to 
Ethernet  switch,  concentrator,  network  card,  computer  signal  and  power  over  voltage 
protection,  exempt  from  the  damage  caused  by  reacting  over-voltage,  operating  over-
voltage and static electricity discharge etc.. It is widely used in conference system, security 
surveillance  system  etc..used  in  meeting  system,  security  surveillance  and  office  ethernet 
project.  

Notice

1) Please make sure that the surge protector output is connected with the protected equipment. 
    The connection should not be reversed!
2) The surge protector doesn't work if not strictly abide by the  grounding  instructions . 

1)
     standards;
2) Please  ensure that the connection is stable;
3) Please ensure that the grounding cable of surge protector is connected with the main grounding   
     cable in the room as short as possible. 

 Before inserting protector into system, please make sure the grounding grid reach the                   

     

Please follow the installation step

Please check the following items before installation, if it s missing please contact the dealer.
   Multichannel ethernet signal surge protector                                          1pc 
   Hanger                                                                                                           1pair
   User  manual                                                                                                 1pc

'

 Installation  Step

Application

ethe

rnet o

ptic

al

   tra

nsce

iver

IP

 

camera

Dome

 

camera

 

Cat5

/5e/6 c

able

NV

R

PTZ

 

Camera

Dome camera

Fib

er

Board Diagram

Multichannel Network Signal Surge Protector

Notice

1)Protector possess signs of input(IN), output(OUT). Please ensure that the output end is   
   connected with the protected equipment, otherwise it will cause the damage of surge protector.
2)Please check the plug if the consumption increases. You can either re-connect it or replace the   
    protector.
3) Please don't un back the component personally

 Front board

Back board

Grounding

8Channel Ethernet Signal Surge Protector

   IN (Line)

Signal input

24Channel Ethernet Signal Surge Protector

   OUT (Equip)

Signal output

Signal output

IN(Line)

IN(Line)

IN(Line)

IN(Line)

IN(Line)

OUT(Equip)

OUT(Equip)

OUT(Equip)

OUT(Equip)

OUT(Equip)

Front board

 

Signal input

Back board

Multichannel Ethernet Signal Surge Protector

Grounding

Surge protector

  Multichannel Ethernet

 Signal Surge Protector

Switch

Отзывы: