USTER HVI1000, Инструкция по эксплуатации, Страница: 56 / 238

USTER®
HVI 1000
Instruction Manual
Uster Technologies, Inc. Chapter 4
(3/08) Configuration
-
Page 4-6
Length/Strength and Color/Trash are processed ONE BALE at a time.
The Length/Strength sampler drums and the Micronaire Color/Trash
tray operate the same as for Mode 1. This mode supports overlap of
testing so that throughput is increased.
2.5.3 Mode 3
Two Bales Overlapped, Bales in Pairs, Single Comb: This Mode is used
for high volume overlapping bales using one comb per bale. Two
different bales are tested at the same time. The Repetitions (L/S Combs)
are fixed and not configurable. There are no Side Limits for
Length/Strength. The Length/Strength combs and each side of the
Color/Trash tray are associated with each of the two bales being
tested.
Example: Bale1=Left Comb, Rear Color/Trash tray;
Bale2=Right Comb, Front Color/Trash tray. All modules for both bales
must be completed before starting the next pair of bales. This is faster
than using Mode 2 as only one length/strength cycle is required for
both bales.
Retesting of modules is processed for each bale. The system will ignore
new data for bales that have already passed and completed, as new
data is being collected for bales that have failed.
2.5.4 Mode 4
One Bale, Single Sampler Drum, with Combs: This Mode is for single
sampler drums testing. The Repetition (L/S Combs) is variable (1 or 2),
but only the LEFT sampler drum is processed for Length/Strength data,
and only one bale is tested at a time (no overlap). No side limits are
allowed to be selected.
Mode 4 is the mode used with the M700 model. This mode supports
the single sampler drum and single comb of this unit.