USTER HVI SPECTRUM, Инструкция по эксплуатации, Страница: 40 / 230

USTER
® HVI SPECTRUM
Instruction Manual
Uster Technologies, Inc. Chapter 3
Note:
The example above applies to all function buttons with the
exception of the
T
ESTING
button. When the testing screens are exited,
all functions on the HVI SPECTRUM M
AIN
M
ENU
are enabled.
2.1.1 Testing
Software Overview • Page 3-4
The T
ESTING
button is used to perform the normal
testing process of fibers. The testing sequence is
described in detail in Chapter 7 .
Figure 3-4: Testing Button
2.1.2 Setup
The
S
ETUP
button accesses a series of functions,
which are described below.
Figure 3-5 : Setup Button
These include the following:
•
Color Chart — is used to define/adjust the color chart(s) settings.
•
Lot Limits — is used to define/adjust the lot limits settings.
•
Configure — is used to define/adjust the system configurations.
•
Diagnostics — is used to perform a series of diagnostic checks to
ensure that the system is functioning properly.
•
System Check — is used to determine whether or not the
HVI
SPECTRUM
instrument requires calibration.
•
Calibrate — is used to calibrate the various testing components.