Controlling the UDMR with MIDI signals
62
UDMR settings
MIDI output (OUT/THRU) settings
This section describes how to switch the MIDI OUT/THRU
terminal.
OUT:
Transmits MIDI data from the UDMR. Select this
function when playing back MIDI phrases and
transmitting exclusive messages.
THRU:
Transmits MIDI data from the MIDI IN terminal
without modification. This function cannot be used
to output MIDI signals from the UDMR.
1. Press the MODE button.
The MODE indicator light comes on.
2. Turn the SELECT dial to '6.1 MIDI OUTPUT' then
press the SELECT dial.
3. Turn the SELECT dial to MIDI OUTPUT
(OUT/THRU) then press the SELECT dial.
4. The confirmation screen is displayed. Press the
ENTER button to execute the operation.
To cancel the operation, turn the SELECT dial to
'CANCEL' then press the ENTER button.
Once the setting is complete, the display returns to the
settings selection screen.
5. Press the MODE button.
The setting is completed and the display returns to the
default screen.
Pressing the MODE button mid-setting displays a confirmation
screen asking you whether or not to cancel the setting. Please
note that selecting 'YES' and pressing the ENTER button
returns you to the default screen and cancels all settings made
up to that point.
Allocating phrases to note numbers
(MIDI note mapping)
Use the Note On data signals to play back phrases
corresponding to note numbers. You can allocate your
choice of phrases to the 128 notes of Program Change 1.
While phrases can be selected from either memory cards A or
B, the memory card on which the selected phrases are
recorded must be inserted during playback or they will not play
correctly (if the phrase does not exist, the playback signal will
be ignored).
You can designate and play back all phrases by combining
Program Change and Note On data (p.64).
1. Press the MODE button.
The MODE indicator light comes on.
2. Turn the SELECT dial to '6.2 MIDI NOTE
MAPPING' then press the SELECT dial.
3. Turn the SELECT dial to select the note you wish
to configure
.
Once you have set the note, press the SELECT dial.
C-1 - G9 (0 - 127): note numbers
END: Completes the setting.
RESET: Restores the same settings as immediately after
formatting.
CLEAR: Erases all of the settings.
4. Turn the SELECT dial to the memory card
containing the phrases to be registered then
press the SELECT dial.
* If you do not want to register any phrase, select [-----].
CAUTION
CAUTION
