urmet domus iPerTAlk 1375, Руководство по установке и настройке

Страница: 19 / 100

19 DS1375-020E
— steady blue or steady green LED: free extension;
— red LED flashing: the extension is ringing;
— steady red LED: extension engaged in a conversation.
Press the corresponding key to:
1 - call the extension associated with the key, when the key indicates its state as free (fixed blue or fixed green);
2 - answer the call addressed to the extension associated with the key (PICK or answer for absent extension),
when the key indicates the ring state (flashing red); such service is available only for Urmet terminals, and is
configured by means of the relevant configuration interface (see the device’s manual).
10.14 PICK GROUP AND DIRECT PICK
iPerTAlk supports the direct pick function (answer for absent extension) of a call addressed to an extension or to
a group of extensions.
This service allows answering a call addressed to an extension, (or a group of extensions) while it is ringing.
The pick function can be applied in two modes:
— pick group: it allows each one of the extensions belonging to the same “pick group” to answer a call addressed
to another extension that is not answering (it is ringing). This mode requires the configuration of the “pick
group” parameter (Administrator User only) on each one of the extensions for which this function is to be
enabled, with the same numerical value.
iPerTAlk allows setting up to 10 “pick groups”.
The user performs the command by pressing the PICK key in the terminal or by lifting the receiver and dialling
the code *35*.
— direct pick: it allows any extensions of a system to answer a call addressed to another extension, that is not
answering (it is ringing).
The user performs the command by pressing the BLF key of his/her own terminal associated with the extension
to be intercepted (when it flashes in red) or by lifting the receiver and dialling the code *37*XXX where XXX are
the three digits of the extension that is ringing. In this case, pick groups are not taken into account.
10.15 POST SELECTION VIA DTMF
iPerTAlk supports the post selection function, namely it allows sending DTMF digits during the calling phase. It
is therefore possible, for example when contacting a service, that it requests to press digits to access telephone
menus (press 1 for..., press 2 for...), dial the requested digits.
Post selection via DTMF is possible only after the call has started with the counterparty and not during the call
activation phase.
10.16 HOT-LINE
iPerTAlk supports the Hot-line function if the terminals connected to it support such function.
The terminal, properly configured, automatically generates a call to a pre-set number, releasing the receiver or
activating the hands-free mode.
In case of Urmet terminals (IP telephones or gateway for analogue telephones), this function can be set from the
telephone menu or by means of the web interface: