urmet domus 1068/005, Руководство пользователя

Страница: 47 / 52

DS1068-020B
47
LBT20769
9.1.6 GPRS/GSM Field Test
Proceed as follows to test the GSM/GPRS field signal level:
1. Access the MASTER / INSTALLER menu by entering the access code. Press to confirm;
2. Select " System Settings " by pressing the key associated with the or symbol. Press to confirm;
3. Select " Test " by pressing the key associated with the or symbol. Press to confirm;
4. Select " GSM field " by pressing the key associated with the or symbol. Press to start the test;
5. The system will show "Waiting for... " on the keypad display, followed by the result of the tests;

GSM OK / KO

GPRS OK / KO

SIM OK / KO / Not present / Invalid PIN
Excellent signal
Good signal
Sufficient signal
Poor signal
6. Press to end the test;
7. Press repeatedly to go back to the upper level menu.
9.1.7 IP interface test
Proceed as follows to check that the IP interface works perfectly:
1. Access the MASTER / INSTALLER menu by entering the access code. Press to confirm;
2. Select " System Settings " by pressing the key associated with the or symbol. Press to confirm;
3. Select " Test " by pressing the key associated with the or symbol. Press to confirm;
4. Select " IP interface " by pressing the key associated with the or symbol. Press to confirm;
5. The system will show "Waiting for... " followed by the result of the tests;

Connected or Not Connected

Access point or Urmet Cloud

IP Address
6. Press repeatedly to go back to the upper level menu.
9.1.8 Supplementary power supply battery test (available only with 1068/010 control panel)
Proceed as follows to check the condition of the control panel battery:
1. Access the MASTER / INSTALLER menu by entering the access code. Press to confirm;
2. Select " System Settings " by pressing the key associated with the or symbol. Press to confirm;
3. Select " Test " by pressing the key associated with the or symbol. Press to confirm;
4. Select
“
PS Batteries
” by pressing the key associated with the
or symbol. Press to confirm;
After the control panel has performed the test, messages concerning the status of the battery will be shown on the display of the
keypad.
In case of failed test one of the following text messages "Low or fault battery", "Low Battery", will be reported.
If the test is successful , the message "Battery OK" will be displayed;
5. Press repeatedly to go back to the upper level menu.