DS1068-020B
25
LBT20769
5
ADVANCED SYSTEM MANAGEMENT
This chapter contains information for complete system management including the procedures which are used less frequently than the
system setting and unsetting procedures.
5.1
SYSTEM ACCESS CODES
Access to given system functions is permitted according to the access code type (Master, User, Installer or Technical Manager). The
available codes are:
1.
Master code
. This code is always enabled and is the only code authorised to enable other users, keys, time scheduler and
remote access. It can be used to reset all the other access codes to the factory default (useful if the changed access code i s
forgotten).
2.
Installer code
. This code must be enabled each time by the Master code and is automatically deactivated when a new valid
code is entered or a valid key is used. The code is also enabled after each system reset. This is to program the system and f or
maintenance. This code is used by the installer. It can be used to reset all the other access codes to the factory default (useful if
the changed access code is forgotten).
IMPORTANT!
The installer code will be automatically deactivated if any Users enter their code while the installer code is enabled. The
same will occur if an electronic or proximity key is used.
3.
User code
. This code must be enabled by the Master code and will remain valid until it is deactivated by the Master code or by a
time scheduler command. This code is used by users for normal operations: setting and unsetting the system, displaying system
status, reading system log and changing the access code.
4.
Technical Manager code
. This code must be enabled by the Master code and is automatically deactivated when a new valid
code is entered or a valid key is used. The code is also enabled after each system reset. It allows to access a limited number of
system configuration functions. It can be used to reset all the other access codes to the factory default (useful if the changed
access code is forgotten).
IMPORTANT!
The enabled Technical Manager code will be automatically deactivated if any User enters their code while the Technical
Manager code is enabled. The same will occur if an electronic or proximity key is used.
Each access code is freely programmable with a variable length from a minimum of four to a maximum of six digits. Each User can
change their access code at will.
Each Users, including the Master and Installer, should change their code before commissioning the system
Always press
to confirm the entered access code to access menus or functions.
IMPORTANT!
Enabling the hold-up function will cancel any compliance with EN50131 standards
