urmet domus 1067/024, Руководство по установке

Страница: 75 / 120

DS1067-063D
75
LBT20064
5.10 INSTALLING THE READER
The proximity and key readers are installed in boxes to be built-in or wall-mounted and positioned in a dry area.
The reader is suitable to be installed on BTicino Magic frame and using BTicino code A5374/1 adapters, on BTicino TT
Matix frames. The adapter frame supplied allows the installation of the reader on the Simon Urmet nea frames.
Moreover, by using the adaptor frames (not provided), the reader can be inserted as a switch in the following civil lines:
Bticino Living International, Bticino Living, Bticino Axolute, Gewiss Playbus, Vimar Idea, Vimar Palna, Vimar Eikon.
IMPORTANT! In accordance with EN50131 standards, the readers installed outside the protected spaces must
be protected by devices to prevent tampering.
IMPORTANT! The absence of the tamper results in the loss of EN50131 certification.
The readers are equipped with two freely programmable auxiliary inputs referring to negative.
To install the reader, follow the instructions below:
1. Connect the reader to the Bus.
2. Install the reader, with the adapter if necessary, on the switch frame available, possibly in a position that leaves it
accessible to the button and to the programming LED located on the side of the reader.
3. Connect the tamper to the input 1 of the reader (yellow wire: interrupt the wire by cutting it and connect the two ends
to the tamper). The TAMPER is the default setting.
4. Connect another optional device to input 2 (green wire: interrupt the wire by cutting it and connect the two ends to the
device).
IMPORTANT! If two readers must be installed near each other in the same box, whether build-in or wall-mounted,
leave at least the space of one switch between them.
For details on connections (power supplies, inputs, bus, etc. …) see paragraphs 5.12.2
Connecting the data Bus and
5.12.5 Connecting inputs .
5.11 INSTALLATION OF THE 1067/092 SUPPLEMENTARY POWER SUPPLY
IMPORTANT! During installation of the control panel, be very careful to not accidentally damage the board.
5.11.1 Fastening to the wall
Figure 52 - Holes for fastening the 1067/092
F
T Holes for fastening to the wall
D Holes for fastening 2 optional 1067/008A expansions
F Band to fasten power supply cables
T
F
D
1067/008A
1067/008A