Urban MilkShuttle, Руководство по эксплуатации

Страница: 69 / 88

Maintenance/Repairs
69
9 Maintenance/Repairs
9.1 Replace wearing part set
Required tools: Hexagon spanner 10 mm, sharp knife
You must replace the wearing part set if the agitator emits unusual noises or
vibrates during operation.
To do so, carry out the following steps:
1. Open the flap of the feed container, cut the 2-ear clamp
➋
in two using a side
cutter and remove the clamp from the shaft of the agitator.
2. Use a hexagon spanner (10 mm) to release the fastening screws of the motor:
3. Lift up the motor slightly and lay it down at an angle:
➊ Slip clutch
➋
2-ear clamp
➌
Trunnion
➍
Bearing bushing
Figure 9/1: Wearing part set (Order No. 230.201)
Figure 9/2: Fastening screws of the agitator motor
1
2 3 4