Urban MilkShuttle, Руководство по эксплуатации

Страница: 32 / 88

Operation
32
Long-term operation
Briefly pressing the key starts the "Long-term operation" function. The
agitator is switched on for 5 minutes (fast or slow). The long-term operation time
cannot be changed. The display alternately shows the target and actual
temperatures and the remaining long-term operation time:
Pressing the key again cancels the long-term operation function.
Briefly pressing the key (less than 0.5 seconds)
shows the current actual temperature for five seconds:
This function can be called up from almost all submenus.
6.2.1 Filling/mixing the feed
6.2.1.1 Mixing calf milk replacer (CMR)
1. Fill 3/4 of the required water amount in the container.
2. Press the key on the operating panel for approx. 2 seconds to
switch on the control. The displays shows the
start window:
CAUTION
Danger of injuries caused by self-starting agitator.
Never reach into the container when the device is switched on!
Mixing tables
In chapter 11 on page 81 you can find three mixing tables, which will facilitate the
preparation of milk feed from water and calf milk replacer. Each table lists the
combination of water amount and milk powder amount needed in order to pre-
pare a given quantity of milk feed with a given solids content. In total three diffe-
rent mixing table variants are available, specifying the water amount in litres or
gallons and specifying the required amount of powder in kilograms or pounds.
Information
Comply with the specifications of your CMR manufacturer for the optimal mixing
temperature.
START
STOP
START
STOP
Heating Agitating
16.3 C 04:59
blinking
1 sec
40.0 C Agitating
16.3 C 04:58
START
STOP
START
STOP
°C/F
Temperature
15.2 C
INFO
INFO
ON
16.07.14 10:30:32
MilkShuttle 105A31