9.
Installing the Light Kit
CAUTION:
Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
Step 1.
Remove the two (2) Phillips headed
shoulder screws from the light kit mounting plate.
(
Note:
Do not remove the two torx head screws.)
(Fig. 16)
Step 2.
While holding the LED light kit under
your fan, make the polarized plug connections:
- Blue to white
- Black to black
Step 3.
Align the torx head screws in the light kit
with the two keyholes in the light kit pan.
Reinstall the two (2) Phillips head screws
previously removed into the threaded holes and
securely tighten. (Fig. 16)
Step 4.
Align the trim ring onto the two (2)
Phillips screw heads on the light kit and turn
clockwise until snug. (Fig. 16)
Figure 16
Screws
Mounting
plate
Wire connector
LED
Light kit
Trim Ring
Installing the battery
Install
12V MN21/A23
battery (included), to prevent
damage to transmitter, remove the battery if not used
for long periods.
Figure 17
