Package Contents
Warnings and Cautions
1of2
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Please go to
for product cleaning tips. Go to the
selection.
marking pen, 1/16”
drill bit, center punch, hammer, drill and wrench.
(1) A21 Medium Base Bulb 150W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.
20-30 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.
www.quoizel.com
Care + Maintenance
Light Source:
Estimated Assembly Time:
Preparation:
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses,
Arm
x 1
C
Lock Ball
x 4
B
A
Mounting Screw
x 3
D
Side Rod
x 2
Fixture Body
x 1
E
STEP 1
Remove Papers Inside of the Cage
-
A. Rotate the bolt and remove it from the bolt holder to open the door.
B. Remove papers inside of the cage.
C. Close the door and place the bolt back onto the bolt holder.
Figure 1
STEP 2
Install Arm and Side Rods
-
A. Place tabs on the ends of the Arm (D) over bolts on the Fixture
Body (E) and secure with Lock Balls (C). Hand tighten until snug.
B. Thread Side Rods (B) onto the Fixture Body (E) and hand tighten
until snug.
D
C
B
E
Tab
Bolt
Figure 2
Door
Bolt
Bolt Holder
Paper
(Remove)
STEP 3
-
Mark the Location for the 3 Mounting Holes
A. Place the light fixture onto the post and mark the location of the 3
mounting holes on the fixture fitter onto the post with the marking
pen.
Fixture
Fitter
Marking Pen
Mounting
Hole
Post
Lighting
Post
Post
Fixture
Fitter
Figure 3
Installation Instructions:
UQL13
7
www.urbanambiance.com
