Uponor Smatrix Move, Быстрое руководство

Страница: 13 / 268

UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
1 3
U P O N O R S M AT R I X M O V E · Q U I C K G U I D E
Q U I C K G U I D E
To change the heating and/or cooling curve:
1. Press and hold the OK button on the controller for
about 10 seconds to enter the system parameters
menu.
2. The settings icon is displayed in the top left hand
corner of the display, and the text Hot type , Cld
type , or rEv type (depending of current operating
mode) is displayed.
3. Use buttons < or > to locate parameter 1 (Cur)
– Heating curve, or 1 (Cur) – Cooling curve. They
are identified using the heating or cooling symbol.
Heating curve:
Default: 0.7
Setting range: 0.1 – 5, 0.1 increments
Cooling curve:
Default: 0.4
Setting range: 0.1 – 5, 0.1 increments
4. Use buttons - or + to change parameter setting.
5. Press the OK button on the controller to confirm
the change and return to the system parameter
settings.
6. Repeat steps 3 through 5 to change the other curve
settings, if needed.
Factory reset
To perform a factory reset, go to system parameter 23
(ALL) – Factory reset, in the controller.
Press and hold the OK button for about 5 seconds until
the controller restarts.
See section Setup the system for more information.
System integration with other systems
(requires antenna A-155 and wireless
thermostat)
The Uponor Smatrix Move controller can be integrated
with another Uponor Smatrix Wave system to enhance
the capabilities of the full climate system. At the same
time, the integration removes the need of a separate
thermostat, and outdoor sensor, for the Move system.
Shared information
Information regarding system state and reference room
temperature is forwarded to the Move controller, which
adjusts the supply temperature accordingly.
Different system states and temperatures which can be
forwarded are:
• Comfort/ECO mode*
• Heating/cooling mode
• Holiday mode*
• Reference room temperature and setpoint
• Outdoor temperature (if installed in the thermostat)
• Remote sensor (if installed in the thermostat)
• Indication if the relative humidity exceeds set limits
(requires the digital thermostat T-168 or T-169, and
interface I-167)
*) Through change of setpoint, using the ECO setback value from the
integrated system. No indication or change of mode is shown in the
Move controller.
The integration is activated when the thermostat is
registered to both controllers (Move and Wave).
See the Uponor Smatrix Wave documentation on how to
register the thermostat to a Wave system.