44
the blades. If the blades are not aligned, the holder can be slightly bent
up or down to align it with the rest of the blades.
If after following all these steps the problem is not solved, a small
adjustment must be made using the balance kid provided.
Turn the fan on and change the speed until the most noticeable swing
occurs (usually the highest speed).
Turn off the fan. Select a blade and place the balancing clip on the edge
of it, between the holder and the tip.
Turn the fan back on and see if the tilt has improved or worsened. Turn
the fan off and change the clip to another blade to check again. Repeat
this process for all blades and note which blade has the most
noticeable improvement.
Put the clip back on the blade where you noticed the greatest
improvement. Move the clip along the blade and turn on the fan to find
the position where the clip offers the better improvement.
Next, remove the clip and place one of the balance weights on the point
where the clip was placed. To do so separate the white sticker with your
fingernails or, if necessary, carefully use a knife or scissors.
4.
USING THE APPLIANCE
This device is very easy to use and does not require much knowledge. However,
we advise you to familiarize yourself with the instructions below.
The fan has 5 power levels that can be selected through the remote control. It
also has a timer of up to 8 hours.
REMOTE CONTROL UVT1317-21 AND UVT27-21 MODELS
The device incorporates a remote control, for a more comfortable and efficient
use.
In order for the remote control to work, it must always be aimed at the fan.
Before you start using it, please take a few minutes to familiarize yourself with
the functions:
