Universal Devices ISY-994i Series, Руководство пользователя

Страница: 407 / 692

Page | 384
13.18.1.4Motion Sensor Trick
To activate the Motion Sensor for reads and writes without pressing the Set button:
•
If you have a helper you can use the On command.
•
If you are alone you will probably have to key with the Off command.
o
Select the Motion Sensor from the device tree.
o
Open the ISY dialogue concerning the MS Options.
o
The Communications Mode dialogue will open asking you to put the MS in
linking mode.
o
Active the MS with motion.
o
Immediately after seeing the state change (this could be to On or Off) click
the Ok on the Communications Mode requester.
o
ISY will read the options from the MS.
o
By the time you change any options the MS will be sleeping again.
o
If the MS is still On wait for it to change to Off. Otherwise activate the MS
again.
o
Immediately after seeing the state change (this could be to On or Off) click
the OK in the Options Settings requester.
o
ISY will write the changes to the MS.
o
If you miss the window you will see Request Failed and have to start over.
13.19 RemoteLinc
RemoteLincs are RF devices, thus require the installation of an INSTEON RF receiver (such
as an INSTEON AccessPoint).
RemoteLincs link differently than other INSTEON devices, this require a separate linking
routine. To link a RemoteLinc to your ISY, click the LINK MANAGEMENT pulldown and
choose LINK A REMOTELINC and follow the on-screen instructions. Since the RemoteLinc
is a battery-saving RF device, it must be put into linking mode whenever adding to the ISY
or making changes (such as adding or removing from a scene). To put the device in linking
mode, hold Button 1 down for 10 seconds, or until the light starts flashing.
To EXIT linking mode, either wait for the RemoteLinc to time out and the LED to stop
flashing (4 minutes), or simply hit the BRIGHT or DIM button. DO NOT hit one of the 6
rocker buttons.
RemoteLincs show up as a multiple nodes on the ISY (one node per button).