Universal Devices ISY-994i Series, Руководство пользователя

Страница: 401 / 692

Page | 378
•
Wait while the ISY initializes communications with the Leak Sensor.
13.16 LampLinc
Most LampLincs will not act as Controllers – they will not notify the ISY or control other
linked devices if turned on or off locally (via the SET button or using load sensing).
LampLincs labeled v4.2 or higher (firmware v33+) should act as Controllers.
13.17 MorningLinc
13.17.1 MorningLinc – 2458A1
65
ISY firmware 2.8.2+
•
Manually link the MorningLinc to the Locks(s)
•
See Link Management Menu to tell the ISY to Start Linking.
•
Select the third option 'Add devices found in links and keep existing links'.
o
If you select 'Remove existing links' it removes all links from the MorningLinc
and due to the security measures on the MorningLinc the PLM can no longer
send commands to it.
• Link the MorningLinc to the ISY by pressing the Set button on the MorningLinc for
3-5 seconds.
o
If the MorningLinc does not appear on the ISY console press the set button
once again and press and hold again.
•
Click on the Finish button on the Linking in Progress dialogue requester.
•
Some dialogue will take place between the ISY and the MorningLinc to create the
links necessary to view and control the device state.
•
The MorningLinc should now be available as a device in the Console and in
Programs.
13.18 Motion Sensor
Motion Sensors are RF devices, thus require the installation of an INSTEON RF receiver
(such as an INSTEON AccessPoint).
The Motion Sensor cannot be linked using Auto Discover. To link a Motion Sensor to the
ISY, please choose the LINK MANAGEMENT pulldown, then NEW INSTEON DEVICE. Enter
the device address manually (found inside the battery compartment), then select the
“2420M INSTEON Motion Sensor” from the Device Type list.
Since the Motion Sensor is a battery-saving RF device, you must put the device into linking
mode to add it to the ISY (and make any changes to the device, such as adding/removing
65 (Universal Devices)