6
As an aside, an expander is a device which increases the dynamic range of a signal. For
example, a 10dB change in the input signal might result in a 20 dB change in the output
signal, thus “expanding” the dynamic range.
There are several other terms related to compression that can be demonstrated by
referring to Figure 2. The amount of compression or gain reduction is typically given in dB
and is defined as the amount by which the signal level is reduced by the compressor.
Graphically, this can be understood by looking at the difference in levels between what
would have been the uncompressed (the output from an amplifier) output level and the
compressed output level. This value is what is displayed by the LA-2A meter when it is
switched to gain-reduction mode.
As mentioned previously, the
compression ratio
is defined as the ratio of the increase of
the level of the input signal to the increase in the level of the output signal. In this
example, the input level is increased by 10 dB while the output level only increases 5 dB.
This would be a compression ratio of 2:1. Lower ratios such as 2:1 result in more gentle
compression. (Note that a compression ratio of 1:1 is no compression at all).
Typically, compressors let you choose a
threshold.
This is the point at which gain
reduction starts to take place. When an audio signal is below this threshold the
compressor acts like an amplifier and there is no gain reduction. Above the threshold the
slope becomes less than 45 degrees, indicating gain reduction and hence compression.
The point at which a compressor transitions into compression is commonly called the
knee
.
In practical compressors, this transition is more gentle than what is depicted in the
diagram.
Many modern compressors provide a control which adjusts the threshold directly. In the
case of the LA-2A, the
Peak Reduction
knob controls both the threshold and the amount of
compression.
-30
-20
-10
0
+10
-30 -20
-10
0 +10
Input Level (dB)
Output
Level (dB)
Compression region
knee
2:1 Compression
10 dB of
compression
Figure 2 - Input/output curve of a compressor with a ratio of 2:1 and a threshold of -20
dB.
