22
8.3 Drain Pump
Large food residues or foreign objects which were not captured by the filters may block the
waste water pump. The rinsing water will then be above the filter.
Warning Risk of cuts!
When cleaning the waste water pump,ensure that you do not injure yourself on pieces of
broken glass or pointed implements.
In this case:
1.
First always disconnect the appliancefrom the power supply.
2.
Take out baskets.
3.
Remove the filters.
4.
Scoop out water, use a sponge ifrequired.
5.
Check the area and remove any foreignobjects.
6.
Install filters.
7.
Re-insert baskets.
9. TROUBLE SHOOTING
FAULT
POSSIBLE CAUSE
TROUBLESHOOTING
Whitish stains remain
on dishes.
Not enough detergent used.
Use the correct amount of detergent, as
instructed in the program table.
Rinse aid dosage and/or water
softener setting set too low.
Increase rinse aid and/or water softener
level.
High water hardness level.
Increase water softener level and add salt.
Salt compartment cap not closed
properly.
Check that the salt compartment cap is
closed properly.
Dishes do not dry.
Drying option is not selected.
Select a program with a drying option.
Rinse aid dosage set too low.
Increase rinse aid dosage setting.
Rust stains form on the
dishes.
Stainless-steel quality of the dishes
is insufficient.
Use only dishwasher-proof sets.
High level of salt in wash water.
Adjust the water hardness level using water
hardness table.
Salt compartment cap not closed
properly.
Check that the salt compartment cap is
closed properly.
Too much salt spilled in the
Dishwasher while filling it with salt.
Use funnel while filling salt to the
compartment to avoid spillage.
A poor mains grounding.
Consult a qualified electrician immediately.
Detergent remains in the
detergent compartment.
Detergent was added when the
detergent compartment was wet.
Make sure detergent compartment is dry
before use.
