MEC4 INVERTED METALLURGICAL MICROSCOPE
UNITRON
10
Assembly
(continued)
Stage Plate
(Fig. 5)
Insert the metal stage insert plate
①
into the opening on the stage.
Eyepieces
(Fig. 6)
Remove the eyetube caps
①
and insert the eyepieces
②
into the eyepiece tubes
③
. Lock in the
eyepieces using the supplied 1.5mm hex wrench to tighten the screw on each eyepiece tube.
Power Cord
VOLTAGE CHECK
Confirm that the input voltage indicated on the rear label of the
microscope corresponds to your line voltage. The use of a
different input voltage than indicated will cause severe
damage to your microscope.
Connecting the Power Cord
Make sure the On/Off Switch is “O” (the off position) before
connecting the power cord.
Insert the power plug into the power jack of the microscope;
make sure the connection is snug.
Plug the power cord into a power supply receptacle.
NOTE:
Always use the power cord that came with your microscope. If your power cord becomes
damaged or lost, please call your authorized UNITRON dealer for a replacement.
Fig. 5
Fig. 6
①
①
②
③
