Unitek BAMOCAR-PG-D3-700-900, Руководство пользователя

Страница: 45 / 50

State display
Version: 2020 / V3 Seite: 44 BAMOCAR-PG-D3-700-900
5 State display
The state "normal" is signaled by a bright green seven-segment d decimal point (display of the
state).
The state
"fault"
is signaled by a bright red fault LED and the seven-segment display indicates the error
no.
The state "warning" is signaled by the flashing red fault LED and the seven-segment display indicates
alternately the state and the warning no.
5.1 Display of the BAMOCAR states
Display Point/segment State State of NDrive
flashing
dark
Processor active
Auxiliary voltage missing or inherent hardware
failure
flashing
bright
dark
Starting state after reset (auxil. voltage 24V off-on).
The first enable stops the flashing display.
Drive enable
Drive disabled (not enabled)
OK = 0
OK = 1, ENA = 1
OK = 1, ENA = 0
bright Speed zero (standstill signal) N0 = 1
bright Drive revolves clockwise, N currently positive N0 = 0
bright Drive revolves anti-clockwise, N currently negative N0 = 0
flashing
bright
dark
Motor current reduced to continuous current Icns
Motor current at max. current limit Imax
Normal operation; Motor current within the current
limits
Icns = 1
Icns = 0
Icns = 0
bright for
0.1 s
A new command (value) was received from the BUS
or RS232.
Example
: Motor revolving clockwise
Point flashes = active processor
Bottom segment = drive enabled
Right segment = motor revolves clockwise