Unitek BAMOCAR-PG-D3-700-900, Руководство пользователя

Страница: 41 / 50

Control connections
Version: 2020 / V3 Seite: 40 BAMOCAR-PG-D3-700-900
4.10 Encoder connection TTL
Only with BAMOCAR-PG-D3-IN
TTL incremental encoder (Encoder)
with 2 counting tracks and one zero
track plus 3 rotor position tracks.
Counting tracks with or without push-
pull output.
With simple connection A, B, N the
negated inputs.
Counter input corresponds to RS485.
Maximum counting frequency 500 kHz.
The incremental encoder is galvanically
is connected to the device zero (GND).
The 5 V supply voltage is provided by
the servo.
Only use motors with TTL incremental encoders and rotor position tracks which have been approved by
the manufacturer.
Connector X7 14-pin Tyco type connector
Connecting cable 11 shielded signal conductors min. cross-section 0.14 mm
2 supply lines min. cross-section 0.5 mm
For link chains use appropriate cables!
Cable length for >25 m the cross-section of the cable used must be increased
Shield connection across connector X7 connect the shield to the
connector housing
across the motor connector connect the shield to the
connector housing
Setting parameters see software Manual NDrive