United Technologies Carrier Transicold 69UG15, Операция и обслуживание

Страница: 32 / 76

T-360 3–2
Figure 3.2 Generator Set Mounting - Quick Mount
3.2 GENERATOR SET REMOVAL
1. Standard Mount
a. Disconnect power cable to generator (if connected).
b. With fork lift in position and safety chain attached, slide mounting plates back sufficiently to clear chassis.
c. Lower and remove generator.
2. Quick Mount
a. Disconnect power cable to unit (if connected).
b. With fork lift in position and safety chain attached, loosen mounting bolts, and lift end of bolts out of slot to
orient clamps to open position.
c. Lower and remove generator.
3.3 STARTING AND STOPPING INSTRUCTIONS
3.3.1 Pre-Start Inspection
1. Check engine lubrication and fuel filters, oil lines, and connections for leaks. If required, tighten connections
and/or replace gaskets.
2. Check engine lubricating oil level. (Refer to Section 2.10 , table entry f.)
3. Check poly V-belt for fraying or cracks and proper tension. (Refer to Section 5.4.11 ).
4. Check radiator hoses for leaks and check radiator coolant level. (Refer to Section 2.10 , table entry j.)
$
$
ROADSIDE VIEW
VIEW A-A
Angle Assembly, Clamp
Washer, Spherical, Male
Washer, Spherical, Female
Bolt
Washer, Spherical Belleville
Roll Pin
Nut, Hex, 3/4-10
Frame Assembly
FORK LIFT POCKET
CONTAINER FLOOR CROSS I-BEAM
REAR OF CHASSIS