Installation
Wiring a field-supplied high-torque actuator to the analog output
You can wire one of the following Belimo actuators to the VAV Zone Controller's analog output instead of using the
controller's built-in, 35 in.-lb (4 Nm) actuator.
NMX24-MFT P-10028
90 in.-lb (10 Nm) actuator with 0–10 Vdc control and 0–10 Vdc
feedback
AMX24-MFT P-10028
180 in.-lb (20 Nm) actuator with 0–10 Vdc control and 0–10 Vdc
feedback
1
Install the actuator according to the manufacturer's instructions.
2
Wire the actuator to the controller using the diagram below.
NOTE
For proper operation and to prevent damage to the devices, use the same polarity for the actuator's power
and the VAV Zone Controller's power.
34
VAV Zone Controllers