W A S H S E L E C T I I
Document Number:
WS21002
134
Document Title:
WSII Operations Manual
2.
Set the dial on the power block to the zero setting.
3.
Using a small flat-head screwdriver, remove the small plastic cover below the dial
on the power block.
4.
Flip dipswitch 1 to the up position.
5.
Replace the power block.
6.
With no vehicle in front of the unit, turn the dial until the relay light (LED) comes
on. You must always keep the dial below this setting.
7.
Next, you must turn the dial toward the lower numbers until the relay light turns off
and then turn the dial one more notch to the left.
It may be necessary to adjust the dial again at a later date if the proximity block "Relay" light
comes on when there is no vehicle present. Too high of a gain setting will give a continuous
false vehicle detection signal.
3.7.3
System Settings Affecting Proximity Sensor Operations
The following Wash Select II system settings will have an effect on how the Proximity Sensor
operates.
Table 27. System Settings Affecting Proximity Sensor Operations
Setting
Effect
Greeting Delay
This defines how long the Wash Select II should
wait to play the greeting message for the first time
after a customer has driven up.
Repeat Delay
This defines how long the Wash Select II should
wait to play the greeting message again if
customer activity has yet to begin. The greeting
message will stop repeating once the customer
initiates an action with the unit, such as adding
money, selecting a wash or swiping a credit card.
3.8
Coin Hopper and Assembly
The Wash Select II is equipped with a Suzo Mark II coin dispenser, which is embedded in a
proprietary Unitec design. The dispenser is able to hold/dispense up to 2,400 quarter-sized
coins. It is located inside the Wash Select II case directly behind the wash selection displays.
3.8.1
Filling the Hopper
The large opening at the top of the coin hopper has been added to increase the holding
capacity of the dispenser. The inclined plane that spans across the top half of the hopper
assembly is used to distribute the weight of the coins. When pouring coins into the dispenser,
you must direct the coins at this inclined plane to protect the moving parts at the bottom of the
hopper. Follow the instructions below to fill the coin hopper.
1.
Open the door to the Wash Select II.