UniqAir Uniq, Руководство пользователя

Страница: 11 / 24

U n i q A i r | 9
3.6 Switching on the device
When the air purifier is plugged in for the first time, it will
automatically run through its start cycle as follows:
1. The device will search for a WiFi connection. The blue
WPS/WiFi indicator will flash for up to 20 seconds.
2. If no previously known network is found, the indicator light
will turn yellow for 3s.
3. The device will search for a WPS signal. The WPS/WiFi
indicator will flash purple for 2 minutes.
4. The WPS/WiFi indicator will flash yellow for a while, and then
switch off completely.
5. When the light is off, the device can be operated manually.
See the next section: 3.7 Using the device manually.
NOTE! The front panel touchscreen buttons will not respond to
touch during the start cycle.
3.7 Using the device manually
The device can be operated manually with the buttons on the glass front
panel.
1. Press the “+” button to turn on the device. The device will start at
power-level 1 and one of the circular power-setting lights will turn
blue.
2. Use the “+” and “ - ” buttons to adjust the airflow (power) to the
desired level. The selected power setting is indicated by the circular
power-setting lights.
3. If desired, turn off the unit by pressing the “ - ” button several times
until none of the blue power-setting lights are on.
NOTE! To use the max setting, press the “+” button once when all the
power- setting lights are on. The text “max” will turn blue in the middle of
the power-s etting ‘circle’.
Whenever you wish, you can also switch to using mobile device control via
WiFi, by following the instructions in the next section 4.