U n i q A i r
| 11
4.5
Replacing the power connector fuse
The UniqAir PRO air cleaner power connector
is equipped with its own fuse.
1.
Disconnect the power cord from the
device.
2.
Open the fuse box of the power
connector by pulling on the tabs
circled in the adjacent picture. The
tabs are the easiest to grip by placing
your thumb on top and your index finger underneath.
3.
The opened fuse box contains two
fuses (see adjacent figure):
•
The rear (1)
fuse is
in use.
•
The front (2)
fuse is
a spare,
unused.
4.
Press the metal lining on one end of
the rear fuse so that it pops up and
falls through the hole in the bottom
of the fuse box. Use a pen or similar object to help you press the
fuse.
5.
Press the front fuse in the same way. The fuse
will pop up at an angle, allowing you to remove
it with your fingers.
6.
If the fuse is tight, gently press it from below
through the hole in the bottom of the fuse box
(see adjacent figure).
7.
Carefully press the new fuse into the rear
socket. You will hear a
CLICK
when the fuse is in
place.
NOTE!
Use only 5x20mm 2A 250V slow (L) fuses.
8.
Press the fuse box closed. The box will snap firmly into place.
9.
Reconnect the power cord to the power outlet.
Содержание PRO
