1.Outline of the F395
5
1-6. Waveform Comparison /
Waveform and Displacement Comparison Procedures
In the Waveform Comparison / Waveform and Displacement Comparison mode,
waveform variations with time / displacement are sampled, and a High/Low Limit
Comparison is performed based on the sampled waveform.
A sequential comparison can be performed with respect to dynamic waveform
variations.
The procedures for performing a Waveform Comparison / Waveform and Displacement
Comparison are as follows:
1. Check to see if a waveform is displayed in accordance with the waveform drawing
procedures. (See "1-2. Waveform Drawing Procedures" P3.)
2. Carry out Waveform Comparison / Waveform and Displacement Comparison settings.
(See "13-2. Setting and Operating Method" P68.)
3. Select the channel number(s) you want to control externally.
(See "4-3. Control Connector Connection" P25.)
4. Provide a load to the strain gauge type sensor (displacement sensor), input START and
other signals, and check to see if operation is performed as set.
1-7. Operation Mode at a Glance
Operation
mode
Usable X-axis
Maximum
sampling
rate
Hold
Waveform
comparison
Capability
of return
Time Sensor Pulse
Multi-Hold
○
×
×
4kHz
9 points for all types
×
×
Hysteresis
×
○
○
2kHz
9 points for all types
×
○
Waveform
Comparison
○
×
×
4kHz
1 point for three types
○
×
Waveform and
Displacement
Comparison
×
○
○
2kHz
1 point for three types
○
×
Hysteresis 2
×
○
○
2kHz
3 points for one type
×
○
Содержание f395
Страница 1: ...Operation Manual F395 DYNAMIC FORCE PROCESSOR 10 Apr 2012 Rev 1 12...
Страница 167: ...21 Outer Dimensions 153 21 Outer Dimensions Unit mm 3 3 5 5 Rear Front Side Panel cut dimensions...
Страница 180: ...Unipulse Corporation 9 11 Nihonbashi Hisamatsucho Chuo ku Tokyo 103 0005 Tel 81 3 3639 6120 Fax 81 3 3639 6130...