Unipulse F377A, Руководство по эксплуатации, Страница: 36 / 152

4 CALIBRATION
35
CALIBRA
T
ION
Chapter
4
4-8.
Actual Load Calibration
Set the actual load value under an actual load.
Setting range:
－
99999 - 99999 (0 is excluded.)
How to set
1.
Press the [SET.] button.
(refer to page 33)
2.
Press the [Calibration] button.
(refer to page 33)
3.
Press the [Actual Cal.] button.
4.
Apply an actual load to the sensor, enter
the actual load value by the numerical
keys and determine with the [OK] button.
Also, set the decimal place here. To
eliminate a decimal point, register by
inputting a numerical value and then
pressing the decimal point key at the end.
。
4-9.
Increment
(This step may be omitted if there is no change.)
Set the increment of the indicated value.
1 、 2 、 5 、 10 、 20 、 50 、 100（
The display changes by the decimal place.
）
How to set
1.
Press the [SET.] button. (refer to page 33)
2.
Press the [Calibration] button. (refer to page 33)
3.
Select page 2,
and press the
[Increment]
button.
4.
Select the
increment and determine with the
[OK] button.
SET. Calibration Page 1
→ →
SET. Calibration Page 2
→ →