Setting Up Network Interfaces
Sageon II 200A (N+1) Power Distribution System
PM990-5202-200, Rev. 6
8-2
8.1.3 Preparations for gateway address set up
•
From your network administrator obtain the gateway IP address
•
Connect a PC to the controller’s network interface (directly or via a network).
•
Power-up the controller.
•
Start Device Installer program.
8.1.4 Gateway IP address set up procedure
•
In Device Installer device list select the address of the unit you want to configure.
•
On Device Installer tool bar click “Manage device configuration button”. A new window
“Device Management” will open.
•
Click “Telnet to Device” button.
•
Telnet window will open, showing a message similar to the one below:
*** Lantronix Cobox Universal Device Server ***
Serial Number 1297-041 Software Version V03.9 (000211)
Press Enter to go into Setup Mode
Note: If Enter is not pressed within 3 seconds the connection will be terminated
.
•
If Enter was pressed within time-out window, a message similar to the sample below will be
printed to Telnet window:
*** basic parameters
Hardware: Ethernet Autodetect
IP addr 192.168.000.098, no gateway set
***************** Channel 1 *****************
Baudrate 09600, I/F Mode 4C, Flow 00
Port 10001
Remote IP Adr: --- none ---, Port 00000
Connect Mode: C0 Disconn Mode: 00
Flush Mode: 00
Change Setup : 0 Server configuration
1 Channel 1 configuration
7 Factory defaults
8 Exit without save
9 Save and exit Your choice ?
Type 0 followed by Enter.
The first item in server configuration is local IP address. That has been programmed already, but
it is necessary to go through all bytes. Information in brackets shows current setting, which can be
modified by typing new entry followed by Enter key. Next item after IP address reads:
Set gateway IP address (N)
[or (Y)]
If value is (Y) – just press Enter, if (N) – press ‘Y’ followed by enter. Next item will be:
Gateway IP address (nnn)
