Page 23
P O W E R I N G T E C H N O L O G Y
Document Number: MS0031-MAN rev. 7
guardian_access_ms31-man-rev7-0521.indd
4.5 Mounting in a Cabinet / Relay Rack
Two mounting brackets installed on the front left and right side of the power system enable
secure fastening of the subrack to a cabinet or a relay rack.
To mount the subrack follow the steps below:
1. Determine the installation position according to the subrack measurement shown in
appendix 4 of this manual.
2. Place the subrack into the cabinet or relay rack.
3. Fasten the subrack into the cabinet or relay rack by using four M6 x 12mm screws and
the mounting brackets on the front left and right side of the subrack. Tighten the screws
to 8Nm (Figure 4-1).
Figure 4-1 Mounting the Subrack (6U system shown)
