Unimotion STDF PD, Руководство пользователя

Страница: 11 / 24

11/24
Table 5-2: Protection functions and LED flash times.
Times Protection Conditions
1 Over Current Error
The current through power devices if inverter
exceeds the limit value of 4.8 A.
2 Over Speed Error Motor speed exceeds 3000 rpm.
3 Position Tracking Error
Position error value is higher than 180°in motor
run state.
4 Over Load Error
The motor is continuously operated more than 5
seconds under a load exceeding the max.
Torque.
5 Over Temperature Error Inside temperature of drive exceeds 85 °C.
6
Over Regenerative Voltage
Error
Back-EMF is higher than limit value.
7 Motor Connect Error
The power is ON without connection of the
motor cable to drive.
8 Encoder Connect Error
Cable connection error in Encoder connection of
drive.
10 In-Position Error
After operation is finished, position error more
than 1 pulse is continued for more than 3
seconds.
11 System Error Error occurs in drive system.
12 ROM Error Error occurs in parameter storage device (ROM).
15 Position Overflow Error
Position error value is higher than 180° in motor
stop state.
5.2 Pulse Input Setting Switch (SW1.1)
Indication Switch Name Functions
2P/1P
Selecting Pulse
Input Mode
Selectable 1-Pulse input mode or 2-Pulse
input mode as Pulse input signal ON: 1-
Pulse mode OFF: 2-Pulse mode (Default:
2-Pulse mode)
Figure 5-2: Pulse input setting switch.