(16)
Fit an Aluminium contact tip of the correct
size to match the wire diameter being used
(10)
Loosen the inlet guide tube retaining screw.
(11)
Remove the inlet guide tube using long
nose pliers.
(14)
Tighten and secure the torch Euro
connector to the machine Euro receptacle
(17)
Fit the remaining front end parts to the
torch neck ready for welding.
(12)
Carefully feed the Polymide liner into the
inlet guide tube hole of the torch Euro receptacle
(15)
Cut the extended Polymide liner with a
sharp Stanley knife just in front of the drive roller
(13)
Take the extended Polymide liner all the
way up and over the drive roller
20
| VIPER MIG 185 Manual
TORCH & WIRE FEED SET UP FOR
ALUMINIUM WIRE
