Unimac ATOIMPUMCA12V Скачать руководство пользователя страница 6

Страница: 6 / 9

12V Adjustable Torque ½" Drive Impact Wrench / Rattle Gun

E&OE

Operation

Fully understand all operational

safety warnings

before using the tool. • Do NOT operate the

tool continuously for more than 10 minutes. • ALWAYS hold the tool firmly with both hands

when operating.

Changing Sockets

Disconnect the tool from the electrical supply.

Hold the tool body firmly with one hand.

Insert the socket (

) fully onto the drive pin (

Each socket has 2 sizes

– reverse the direction

of the socket when installing, as required.

To remove a socket, disconnect the tool from the
electrical supply, then pull the socket directly from
the drive pin.

Setting Torque

ALWAYS set the torque to the correct Nm value for the fastener. For
vehicle fasteners, consult manufacturer instructions for correct torque

values. • When the torque is set, the display may returns to "000" although the
set torque value remains.

• Do NOT change torque value while the tool is

running.

• At next use, the tool will automatically apply the last used torque

setting.

The tool features torque setting. When set, the tool will automatically
disengage the drive pin when the fasteners is at the set torque value. This
helps prevent the possibility of over-tightening fasteners. The current torque
value shows on the display (

•

To increase torque, press (

) as required. Torque starts at 80Nm and

increases by 10Nm for each press. Maximum torque is 340Nm.

•

To decrease torque, press (

) as required. Torque decreases by 10Nm

for each press. Minimum torque is 80Nm.

•

To reset the tool to the factory default torque setting, press (

) and (

)

simultaneously.

Selecting Direction

When the forward / reverse selector (

) is in the middle position, the

trigger is "locked". • The image shows the tool in "forward" mode. • Do
NOT change direction while the tool is running.

The drive pin can rotate "forward" (right or clockwise) for screwing in /
tightening. Similarly, the direction of rotation can be "reverse" (left or anti-
clockwise) for screwing out / loosening.

•

To rotate forward, push the trigger (

) "

▼

" arrow.

•

To rotate in reverse, push the trigger (

) "

▲

" arrow.

UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC `

UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC