Unimac AIRDRLUMCAK06 Скачать руководство пользователя страница 5

Страница: 5 / 7

6 PC. Air Drill Kit

Set-Up

NOTE: If you are not using an automatic oiler system, before operation, add a few drops of Pneumatic
Tool Oil to the airline connection. Add a few drops more after hour of continual use.

1. You will need to prepare a 1/4" air connector (not included) to connect to the air inlet on the cut-off tool. First,

wrap the 1/4" air connector with pipe thread seal tape (not included) before threading it into the inlet.
Connect the 3/8" ID air source hose (not included) to a quick-disconnect coupler (not included) and then to
the cut-off tool.

2. Set the air pressure on your compressor to 90 PSI. Do not exceed the recommended air pressure of 90 PSI.

3. Check the air connection for leaks.

4. Disconnect from the air hose until next instructed to reconnect.

Operating Controls Chuck

When mounting a drill bit in the chuck, insert bit so that the full shank of the bit is held in the chuck. Tighten the
chuck securely by inserting the chuck key into one of the side holes in the chuck and turning the key clockwise.
Before attempting to drill, check that the bit is held centrally in the chuck jaws and ensure the chuck key is
removed. To release the chuck, insert the key and turn it counter-clockwise.

Forward/Reverse Selector

Push the selector to the "F" position to select normal clockwise rotation. Always drill in this direction. Push the
selector to the "R" position to select counter-clockwise rotation. Do not change direction while drill is in motion.

Trigger

Depressing the trigger will allow the drill to rapidly begin rotation in the selected direction. Release to stop.

UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC `

UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC