Quick Release
Charger
Battery & Charge
Indicators
3 x Brightness
Settings
5 x Colour
Temperatures
www.unilite.co.uk
CRI-2300
FEATURES
• Super bright 2300 lumen 20W High CRI 96+ COB LED
• 5 Colour temps: 2700k / 3500k / 4500k / 5500k / 6500k
• Dual power - rechargeable and mains
• Super tough aluminium, nylon & TPR construction
• Built-in aluminium heat sink
• 180° Rotating stand with hole for tripod or magnet
• Adjustable head to change light angle
• IP65 dust & water resistant
• IK07 shock resistant
• Battery level and charging indicator LEDs
• 5m Mains multi-country quick release charger/power lead
• Fast 3½ hour charge time
BATTERY - 11.1v 4400mAh Li-ion Rechargeable Battery
WEIGHT - 1150g
DIMENSIONS - W 224 x H 199 x D 74mm
OPERATION
TOP SWITCH
- this is the ON/OFF switch and Battery display. Press
once to turn lamp ON. It will also display the battery level remaining.
MIDDLE SWITCH
- this operates the CCT. When the lamp is ON, press
to cycle through the colour temperatures - 2700k > 3500k > 4500k >
5500k > 6500k.
BOTTOM SWITCH
- this operates the brightness level. When lamp is
ON, press to cycle through - 550 lumen > 1100 lumen > 2300 lumen.
[If left in any mode for over 3 seconds, the next press will turn off]
[Memory function - the lamp remembers the last CCT and Brightness
settings used, and will turn on with these modes the next time you turn
the lamp on]
ADVICE & IMPORTANT INFORMATION!
LEDs will become hot when switched on; do not touch and never place face down on
any surface – risk of fire! Even once the lamp has been switched off, DO NOT place
face down as the LEDs will stay hot/warm for a while.
Do not look directly at the LEDs. Do not operate in direct sunlight or extreme
temperature conditions (below -10°C or above 40°C).
Do not use the device if there is any visible damage to the housing, LED, charge port
or charger & cord. Take care when using the charger, always check for any damage
first. Only use the charger supplied with the lamp or damage may occur. Never
remove the charger from the mains power socket with wet hands, and do not attempt
to remove by pulling the cord, always grasp the plug unit.
The rechargeable battery will reach full performance after a few complete charging
and discharging cycles.
To keep the rechargeable battery in optimum condition, it should be recharged every
3-6 months, especially if it is not being used for a long period of time. Always fully
charge batteries before storage.
Always protect batteries from heat, intense sunlight, fire, water and moisture – danger
of explosion!
If a battery is damaged, fluids can leak out. AVOID contact as this can lead to skin
irritation and/or burns. If skin contact occurs, rinse thoroughly with water. If irritation
persists, seek medical advice. Seek immediate medical assistance if lithium battery
fluid comes into contact with the eyes.
This is not a toy, children under 12 years of age should only use the product under
adult supervision.
Do not open, disassemble or attempt to modify the product; this will void the
warranty and can be dangerous. Improper use or modification is not covered under
the warranty.
Take care not to let the lens come into contact with hard/sharp objects, damage/
scratches to the lenses will affect light output.
This product is water resistant to IPX5 – DO NOT SUBMERGE. If the product has been
subjected to excessive moisture/water the warranty may be void.
This product has a 2 year warranty against manufacturing faults and defects. It
does not cover normal wear and tear, modifications, accidental damage or poor
maintenance. Unilite warranties do not cover battery leaks or the use of incorrect
chargers and cables that can damage the battery.
Do not dispose of this device in normal household waste. It must be disposed of via
an authorised electrical appliance disposal centre or at your local waste disposal unit.
Please re-use or recycle packaging where possible.
Keep these instructions for future reference or for subsequent possessors.
CHARGING
1. Only use the 15V 1.5A quick release charger provided otherwise
damage may occur and warranty will be void.
2. Lift the charging port cover on the top of the lamp.
3. Plug the quick release end of the cable into the charge port.
4. Plug the AC/DC plug into a mains AC plug socket.
5. The battery level indicators will illuminate and flash to show
charging status. Once fully charged, all the indicator lights will
illuminate continually.
6. Charge Time: 3½ hours
The intelligent battery and charging lead means the light can still be
used during charging. Even with a fully charged battery, the lead can
be used as a constant power supply.
**Warranty void if not used with the supplied charger**
2H
2300
Lumens
58M
HIGH
MEDIUM
1100
Lumens
43M
4H
LOW
550
Lumens
26M
8H
ANSI FL 1 Standard
