Unigas C120A, Руководство по установке, Страница: 42 / 116

PART IV: MAINTENANCE
42
Replacing the electrodes
To replace the electrodes
1
Remove the cover
2 Disconnect the electrode cables
3 Loose the screws
4 Remove and replace the electrodes, observing the electrodes position (see previous paragraph)
Replacing the detection electrode (if provided)
To replace the ignition electrodes, proceed as follows:
1
remove the burner cover
2 disconnect the electrodes cables ( CR );
3 loose the screw of the electrodes support ( VR );
4 remove the electrodes and replace them paying attention to the measures shown in
figure.
Adjusting the electrodes
Important Note: Check the ignition and detection electrodes after removing/adjusting the combustion head.
ATTENTION: avoid the ignition and detection electrodes to contact metallic
parts (blast tube, head, etc.), otherwise the boiler’s operation would be com-
promised. Check the electrodes position after any intervention on the com-
bustion head.
ATTENTION: avoid the ignition electrodes to contact metallic parts (blast tube, head, etc.), otherwise the boiler’s operation
would be compromised. Check the electrodes position after any intervention on the combustion head.
ATTENTION: avoid the ignition and detection electrodes to contact metallic parts (blast tube, head, etc.), otherwise the boi-
ler’s operation would be compromised. Check the electrodes position after any intervention on the combustion head.
CR
VR
Detection electrode
Detection electrode
(if provided)
Earth electrode
Ignition electrode
E165A