General Information
Licenses
General Information
Licenses
All Wireless Service Gateway WSG modules must have allready a valid software license. The
license number can be found in the application’s GUI in the Setup Wizard, on the Configura-
tion page (the first view), on the Advanced Configuration page in System Setup > Common > Li-
cense.
The MAC Address
The MAC address can be found on a label on the products rear side, in the application’s GUI in
the Setup Wizard, on the Configuration page (the first view) and on the Advanced Configuration
page in Troubleshoot > System Information. It is also found in the Boot Mode GUI under System
> Information.
Authentication and Administration
Administration is done via a web browser. The administration pages require a user name and
password.
The default passwords need to be changed to prevent unauthorized access to the admin-
istration pages.
Authentication
GUI pages on the Wireless Service Gateway WSG module always have two different user ac-
counts; “admin” and “sysadmin”. Some applications also have additional accounts called “user”
and “ftpuser”.
The
admin
account with the default password “changeme
”
, is used for administration and simple
troubleshooting of the module. The admin has permission to change all passwords except the
sysadmin password.
The
sysadmin
account with the default password “setmeup”, is used for advanced trou-
bleshooting. The sysadmin has access to all administration pages and has permission to change
passwords for all users.
The additional account
user
with the default password “password”
,
is found in some Wireless
Service Gateway WSG applications. This user is application dependent and the field of appli-
cation is described in the corresponding application documentation. This user does not have
access to the administration pages where passwords normally are changed, but the user can
change its own password on the following page; http://xxx.xxx.xxx.xxx/admin/public/user_ch-
pass.shtml. The password can also be changed by the admin and sysadmin.
The additional account
ftpuser
with the default password “changemetoo”, is found in some Wire-
less Service Gateway WSG applications. The user is available in products with an FTP area.
This user can change its own password on the following page; http://xxx.xxx.xxx.xxx/admin/pub-
lic/ftpuser_chpass.shtml.
A31003-M2000-J109-01-7631, 30/06/2020
8
Wireless Service Gateway WSG, Installation Guide
