Additional System Settings
Default Category
The UNS Default Category is used to decide where messages from the WSG shall be sent. The
messaging handler is default set to localhost (127.0.0.1) which is the internal message group
handler in the module. This can be changed if you want to use a messaging handler in another
module. This parameter is changed for example if your system is connected to another WSG.
1)
To set Default Category, click “Default Category”
Figure 30: The UNS Default Category Page
2)
Enter values for Messaging handler IP address and Messaging handler service name. (De-
fault service name is DGH which is the internal message group handler.) If you, for example,
want to send messages to a WSG connected to a WLAN system, enter the IP address of the
module and set messaging handler to WLAN.
3)
Click “Activate”.
Alias / Call ID
Alias can be used when there are numbers that do not belong to the default category.
1)
To set Alias, click “Alias / Call ID”
Figure 31: The UNS Alias/Call ID Page
A31003-M2000-M105-01-76A9, 29/06/2020
Wireless Service Gateway WSG, Administrator Documentation
63
