Startup
A31003-C1000-M101-1-76A9, 03/2016
24
OpenScape Desk Phone CP200/400/600, Administrator Documentation
inbetriebnahme.fm
Quick Start
2.2.6
Key Module
A key module provides additional program keys. The following table shows which key modules
can be connected to the particular phone types.
The configuration of a key on the key module is just the same as the configuration of a phone
key.
2.3
Quick Start
This section describes a typical case: the setup of an OpenScape Desk Phone CP endpoint in
an environment using a DHCP server and the web interface. For different scenarios, cross-ref-
erences to the corresponding section of the administration chapter are given.
2.3.1
How to Access the Web Interface (WBM)
Prerequisites
•
The phone´s IP address or URL is required for accessing the phone´s web interface via a
web browser. By default, the phone will automatically search for a DHCP server on startup
and try to obtain IP data and further configuration parameters from that central server.
•
If no DHCP server is available in the IP network or if the DHCP parameter is disabled, the
IP address, subnet mask and default gateway/route must be defined manually.
•
To obtain the phone´s IP address, proceed as follows:
1. Access the local phone´s Admin menu as described in Access via Local Phone.
•
If DHCP is
enabled
(default): In the
Admin
menu, navigate to Network > IPv4 config-
uration > IP address. The IP address is displayed.
Phone Type
Key Modules
additional keys per module
OpenScape Desk Phone CP200
-
-
OpenScape Desk Phone CP400
2
16
OpenScape Desk Phone CP600
4
12
>
Alternatively, the DLS (Deployment Service) administration tool can be used. Its
Plug & Play functionality allows to provide the phone with configuration data by as-
signing an existing data profile to the phone’s MAC address or E.164 number. For
further information, see the Deployment Service Administration Manual.
>
Any settings made by a DHCP server are not configurable by other configuration
tools.
