measurements
contents
Length: 10’7” (323cm)
Width: 33” (84cm)
Thickness: 4,75” (12cm)
Volume: 258L
1 inflatable board
1 double action pump
1 air hose
1 fin (8”)
1 fin (9”)
1 repair kit
1. inflate your board
• Unroll your board on a flat surfacte. Grass is ideal.
• Make sure that
the pin of the
valve is in the
upper position.
Lightly push it
downward and
twist it to the right
or left until it pops
up.
• Connect the
air hose to the
pump and plug the end piece of the hose into the valve
of the board. Turn the end piece clockwise to secure the
connection.
• Start pumping. The pump has a red handle. Turn it to the
right for double stroke action. When pumping becomes
too heavy, switch the handle to single action. Pump up the
board to 17-20psi.
• Put the cap onto the valve.
1. deflate your board
• Place your board on a flat
surface.
• Take off the cap of the valve.
• Push the valve pin down and
twist the pin so that the pin stays
down.
• The air comes out with a
powerful blast. Be aware.
• Deflate the board as far as
possible.
This inflatable board is meant for practising the sport of stand-up paddling, windsurfing or just having fun on the water. It’s
not a life-saving device. We recommend to wear a personal floatation device and to use a leash while SUPing. Before going
out on the water, inform yourself about the weather and water conditions. Strong winds or strong currents can lead to life-
threatening situations. And of course going out in a thunderstorm is always a bad idea.
2. roll up your board
2. mount the fins
• Your board has 2 fins. The large fin goes in front
• Flip you board upside down
• Connect the end of the fin screw to
the small square plate and place the
square plate in the front end of the fin
box.
• Place the back end of the fin (with the
metal pin) in the fin box and slide the
fin backward. Push the entire fin base
into the fin box.
• Slide the square
plate directly below
the hole in the fin
base. Connect
the screw with
the square plate
through the hole.
Tighten the screw
with finger and
thumb.
• You’re ready to
have fun on the
water!
how to set up your board
how to pack up your board
enjoy responsibly!
1. Deflate your board as far as possilbe.
2. Fold the board right
behind the center fin.
3. Fold the board right in
front of the center fin. Keep
folding back and forth.
5. Lay the rear finbox on
top. Make sure that the
finbox lies flat!
Don’t use exessive force
to roll up your board! It
could cause puncture or
break the finbox!
