UIP200 User's Manual
Page 7 of 27
Rev. 1.0, © UAC, May, 2004
Important Safety Considerations
When using this product, basic safety precautions should always be followed to
reduce the risk of fire, electrical shock and injury to persons, including but not
limited to the following:
#
#
#
#
#
#
#
#
#
#
#
#
Read and understand all instructions.
Follow all warnings and instructions marked on the product.
Unplug this product from the wall outlet and network connection before
cleaning. Do not use liquid cleaners or aerosol cleaners. Use a dry cloth for
cleaning.
Do not
use this product near water; for example, near a sink or in a wet area.
Do not
place this product on an unstable cart, stand, or table. The telephone
can fall, causing serious damage to the unit.
Slots and openings in the cabinet and the back or bottom are provided for
ventilation. To protect the product from overheating, these openings must not
be blocked or covered. This product should never be placed near or over a
radiator or heat register. This product should not be placed in a built-in
installation unless the proper ventilation is provided.
This product should be operated only from the type of power source indicated
on the marking label. If you are not sure of the type of power supply to your
home, consult your dealer or local power company.
Do not
allow anything to rest on the power cord. Do not locate this product
where the cord will be damaged by people walking on it.
Do not
overload wall outlets and extension cords, as this can result in the risk
of fire or electrical shock.
Never push objects of any kind into this product through cabinet slots, as they
may touch dangerous voltage points or short out parts that could result in a risk
of fire or electrical shock. Never spill liquid of any kind on the product.
To reduce the risk of electric shock, do not disassemble this product. Contact
qualified service personnel when some service or repair work is required.
Opening or removing covers may expose you to dangerous voltages or other
risks. Incorrect reassembly can cause electric shock when the appliance is
subsequently used.
Unplug this product from the wall outlet and network connection; servicing to
be performed by qualified service personnel under the following conditions:
1. When the power supply cord is damaged or frayed.
2. If liquid has been spilled onto the product.
3. If the product has been exposed to water or rain.
4. If the product does not operate normally when following the operating
instructions. (Adjust only those controls that are covered by the operating
