UIP200 User's Manual
Page 17 of 27
Rev. 1.0, © UAC, May, 2004
Step 2: Enter the destination telephone number.
Step 3: Press the
DIAL
key to initiate the connection immediately. If you wait
approximately four seconds after you enter the last digit enter, the phone will
automatically connect.
Using On-Hook Dialing
You can also enter telephone numbers before picking up the handset or activating
the speakerphone (while the telephone is in standby mode).
Step 1: Enter the destination number.
Step 2: Pick up the handset or press
HEADSET
/
SPEAKER
to make the phone go off-hook.
Step 3: Press the
DIAL
key to initiate the connection; if you wait approximately four
seconds after you enter the last digit enter, the phone will automatically connect.
Receiving Calls
When there is an incoming call, the
VISUAL RINGER
LED will flash and the LCD
will display the number and name (if available) of the calling party. To answer the
incoming call with the handset, simply pick up the handset. To answer an incoming
call with the speakerphone or headset, leave the handset in the cradle and press the
HEADSET
/
SPEAKER
key.
JOHN DOE
8175553198
Figure 5 LCD display when Receiving a Call
Adjusting the Volume
You can control the volume separately for the handset, the headset, the
speakerphone, and the ringer.
Changing the Handset Volume
Step 1: Pick up the handset.
Step 2: Press
▲
(
UP
) or
▼
(
DOWN
) to adjust the volume.
