DECT 1010 QSG/OM 1
30/9/11
4.
Press the number key (
0
-
9
) you
want to assign to this memory dial
entry. You will hear a confirmatio
tone.
3.
Press
MEM
again.
• If you need the phone to wait before
sending the next set of numbers,
press
PAUSE
to insert a two-second
pause. Each pause counts as a digit.
• If you don’t press any keys for 30
seconds, the phone times out and
returns to standby.
1.
When the phone is not in use,
press
MEM
. The
TALK/BATT LOW
light flashes.
2.
Use the keypad to enter the phone
number exactly as you would dial it.
Additional Features
Ringer Tone
Earpiece Volume
Using Call Waiting
Using Memory Dial
When the phone is not in use, press
UP
or
DOWN
to cycle through the 2 ringer
tones at low, medium, and high volume.
During a call, press
UP
or
DOWN
to
select one of the 6 volume levels.
If you subscribe to a Call Waiting service
through your telephone company then a
call waiting tone sounds while you are on
a call. To switch between calls:
For Australian model;
Press
FLASH
and then press
2
.
For New Zealand model;
Press
FLASH
.
Storing numbers in memory dial
Step 6 Make & Receive Calls
To Make a Call
Listen for dial tone.
Press
TALK
.
Dial the desired number.
To Receive a Call
Pick up the handset
and press
TALK
.
To Hang Up a Call
Press
END
or return the
handset to the base.
To Redial a Number
Press
TALK
and then press
REDIAL
.
Step 5 Connect to the Phone Line
Plug the other end into the
telephone wall jack.
Plug one end of the t
elephon
e
cord into the base
TEL LINE
jack.
New Zealand
Australia
To TEL LINE
Telephone
line cord
To telephone socket
Place the handset on
its base to charge.
Make sure that the
TALK/BATT LOW
light is on to indicate
charging.
Fully charge the battery pack by
placing the handset on the base
before using the phone (about 15
hrs). When fully charged the battery
will provide up to 7 hrs of talk time
and 6 days standby time.
Step 4 Charge the Handset
Step 3 Set up the Base
Note Use ONLY the Uniden
AC adaptor supplied with
your new phone!
Plug the
AC adaptor cord to
the
DC IN 9V
jack.
Plug the
AC adaptor to a
240V
AC power outlet.
AC adaptor (supplied)
To DC IN 9V
To AC outlet
Step 2 Install Handset Battery Pack
Note Use ONLY the Uniden
battery pack supplied with
your new phone!
Remove the
cover.
Connect the battery pack
with the correct polarity.
Replace the cove
r.
Step 1 Check the Package Contents
Base
Handset
AC adaptor
(AAD-041S(M))
Make sure your cordless phone's
packaging includes the following items.
Rechargeable
battery
pac
k
(BT-694m)
T
elephone
cord
Battery
Cover
Optional: Wall Mount Bracket
Start Here!
Quick Start Guide / Owner’s Manual
DECT 1010
