FOODBOX TOUCH, FOODBOX LONG TOUCH, FOODBOX LIFT TOUCH
Page 20
Version 1.3 / December 2018
7.0 CoNTRoL
7.1 Controller board
Controlling the operation of vending machine assemblies and equipment is executed by the control
board (hereinafter – controller), which is located in the control section (fig. 2 pos. З).
The vending machine can operate in two modes in accordance with the embedded software algorithm
- the control program (hereinafter – firmware):
-sales mode (main operating mode);
-service mode (designed for specialists).
The main mode of operation is the sales mode. In this mode, the customer service is carried out
(products selling, storage and giving out). Entry in this mode is realized immediately after the controller
activation.
The service mode is intended for testing the vending machine equipment, setting the parameters
of assemblies and equipment, controlling the vending machine critical parameters, price management.
Changing to the service mode is executed by pressing the service keys (see above).
1. A button for accessing the operator menu (used as a backup button in the cases when the service
button is not connected).
2. A button for accessing the menu technician (used as a backup button in the cases when the ser-
vice button is not connected).
3. USB-flash drive connector.
4. The connector is not used.
5. Modem connector.
6. RS232 card reader connector.
figure 12 - Main board (controller)
1
2
4
5
9
8
3
7
6
10
11
12
