unicraft 6706030, Руководство по эксплуатации

Страница: 12 / 46

12 PG-E-Series | Version 2.08
Start-up
Fig. 8: Mounting of the wheels and bumpers
Install the handle assembly
Step 1: Insert the handle bracket onto the generator
frame and secure with two M8 bolts and two M8
flange nuts (Fig. 9).
Step 2: Align the handle assembly holes with the handle
bracket holes and secure with one bolt and one
M8 flange nut.
Fig. 9: Install the handle assembly
Mounting of the battery
Insert the battery into the holder and screw on the retai-
ning clip (Fig. 10).
Fig. 10: Mounting of the battery
8 Start-up
Locknut
Support
Rubber pad
Flange bolts
Handle
Handle grip
Pin
Battery
WARNING!
Danger of life!
Failure to observe the following rules entails a risk of
injury for the operator and other persons.
- The operator must not work under the influence of
drugs, alcohol or medication and in case of tired-
ness or if suffering from an illness that impairs con-
centration.
- The generator must be operated by one person
only. Additional persons must keep out of the work
area during operation.
DANGER!
Risk of crushing!
Improper work on the generator may result in injury
to fingers and hands.
- Never reach into the generator during operation.
ATTENTION!
Starting the motor when the oil level is insufficient
can cause serious damage!
Check the fuel level: use only clean and warer-free
fuel.
The fuel is highly flammable and explosive under cer-
tain conditions. Refuel in a well-ventilated environ-
ment with the motor switched off. Do not smoke
during refuelling and do not use an open fire.
Never work with the generator before the air filter has
been inserted, otherwise the service life of the motor
and generator will be reduce.
NOTE!
- Operate the generator in a clean, dry environment.
Do not expose the generator to excessive dust, dirt,
moisture or vapors.
- The cooling fins must not be clogged by foreign ob-
jects.
Use protective goggles!
Wear safety boots!
Wear protective clothes!